DRIVE SHAFT-inertia welded shaft with welded, single-lead hardened steel worm at front to drive the wheel worm gear, and welded six-lead hardened steel worm at rear to drive the tiller gear (also includes pressed-on #1714 rear roller bearing, race for bearing; and #9301 key)
MTD-10380
5
Washer, Flat, 1.50 x 1.75 x .010 Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-10 thousandths of an inch (.005"-.010") end play on drive shaft.
MTD-736-04308
5
BLADE:46":SIDE:HOP 532-405380 Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-10 thousandths of an inch (.005"-.010") end play on drive shaft.
MTD-742-05107-4046
5
Washer, Flat, 1.50 x 1.75 x .005 Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-10 thousandths of an inch (.005"-.010") end play on drive shaft.
MTD-736-04306
xx
Shim Set includes the following shims: two #1224-1; two #1224-2; one #1224-3
MTD-GW-1325C
Special Order — Manufacturer is currently out of stock and awaiting replenishment. Usually ships within 2 to 6 weeks. (You can still cancel at any time prior to shipment.)
