You are here: Home > All Brands > Kirby > Kirby Generation III G3 G10 Belt Replacement Guide

How to Replace a Kirby Generation III G3 Carpet Shampoo Nozzle Belt
How-To Belt Changing Guide for These Models:
| Kirby Sentria G10 | Kirby Ultimate G Diamond G7 | Kirby Ultimate G |
| Kirby Generation IV G4 | Kirby Generation III G3 | Kirby Heritage I | Kirby Heritage II |
| Kirby Legend I | Kirby Legend II |

1. Open the Nozzle

To replace the Carpet Shampoo System Nozzle Belt, push the thumb pads located at each end of the shield and rotate the shield up and away from the brush.

2. Remove the Brush

Push down carefully on the ends of the brush with your thumbs. The brush will snap out and the belt can be replaced. Be certain the belt is placed in the center of the brush.

3. Replace the Brush

Align the metal ends of the brush with the slots on the tray and push the brush in until it snaps into place. The brush will only fit the tray the correct way.


Special Note: Be sure to store the unit with the belt unstretched. Make sure the green arrows line up when storing to extend the life of your Carpet Shampoo System Nozzle Belt

If you have any questions about the belt you need for your Kirby Carpet Cleaner attachment, please contact us! We have all the parts you need for your Kirby machine.

Select your model below to see all the parts!

| Kirby Sentria G10 | Kirby Ultimate G Diamond G7 | Kirby Ultimate G |
| Kirby Generation IV G4 | Kirby Generation III G3 | Kirby Heritage I | Kirby Heritage II |
| Kirby Legend I | Kirby Legend II |

All Kirby Vacuum Parts